CEKOL WG-50 Self Levelling Compound FAST SET (3-50mm)

APPLICATION AND PROPERTIES:

• CEKOL WG-50 is used for manual or mechanical covering of primers and substrates for ceramic and stone tiles, PVC covering, textiles, panels, wooden floors etc.
• It can be applied only indoors on stabilized and dry mineral surfaces, in rooms with relative humidity up to 70%.
• CEKOL WG-50 mortar can be applied in the layers of thickness of 3 to 50 mm, as a composite screed on a separating layer or as a floating base.
• The mortar can also be used in floor heating systems applications.
• CEKOL WG-50 is a dry mixture of synthetic gypsum, mineral fillers and modifying additives.

PREPARATION OF THE SUBSTRATE:

The substrate should be clean, compact, carrying and free of grease. Before covering, the base must be stabilized and dry. Tensile strength of the base, in the case of composite layer, should be greater than 1.5 MPa.

PRIMING:

Before covering, the substrate should be primed twice with CEKOL DL-80 emulsion. The screed should be separated from walls and expansion joints existing in the substrate should be moved to the surface after binding. The maximum single surface without internal expansion joints is 50 m2. In the case of very weak substrates, CEKOL WG-50 screed should be made on a separating layer. The thickness of the base on a separating layer and as a floating primer should be minimum 35 mm. The thickness over the heating element – at least 10 mm.

PREPARATION OF THE SUBSTRATE:

Pour the contents of the package into the water in a proportion of about 7 liters of water per 20 kg of dry powder and mix until a uniform mixture is obtained. After 5 min. mix the mortar thoroughly again. The mortar should be used within 30 minutes from mixing. In the case of mechanical covering, find the right amount of water to reach the desired consistence.

LAYING AND CURING:

Cover the ready substrate with the liquid mortar and level with a trowel or a patch and vent with a spiked roller, brush or rake. When laid, the fresh mortar must be protected from direct sunlight and sufficient ventilation in the room must be provided. In the case of heated surface, turn off the floor heating before covering. It can be turned on after 7 days.

FURTHER WORKS:

Floor coverings, parquet, panels and ceramic tiles can be laid when the screed is completely dry (less than 1% of moisture). In the event of tarnish on the surface it should be grinded down, which will facilitate and speed up the drying process. Before sticking ceramic tiles it is recommended to prime the surface with CEKOL GS-83 KONTAKT. Stick the tiles using the two-sided method preferably, using flexible adhesives such as CEKOL C-10 or CEKOL C-11. Available for pedestrian traffic: ~ 6 hours at + 18ºC. Drying time: ~1.5 mm per day. Coverage: ~ 15 kg/m²/1cm of layer thickness. Work temperature: +5ºC to + 25ºC.