Mineral Wool Adhesive Cekol Termo W1...

Mineral Wool Adhesive Cekol Termo W1 25kg

CEKOL TERMO W1 is applied to sticking the thermal external insulation of mineral wools slabs to mineral surface, inside and outside of the buildings.

WATER AND FROST RESISTANT

NON-ABSORBENT

PLASTIC

SUITABLE FOR MANUAL OR MECHANICAL APPLICATION

COVERAGE 5.5 SQM PER BAG

PRICE PER 25KG BAG

€13.99
Tax included

Description

INSTRUCTIONS FOR USE

THE SURFACE PREPARATION

The surface should be clean, closed and free from grease. Paint, loose grains of sand and plaster and any layer temporally connected to the ground should be removed.

PRIMING

High-absorbed surfaces and exposed to moisture should be grounded with the priming emulsion CEKOL DL-80.

MORTAR PREPARATION

Pour the package contents to cold water in a ratio of 5 to 5.5 litres of water per 25 kg bag and mix thoroughly, preferably with a mechanical stirrer. Then wait for approximately 3 minutes and again mix well. The time of mortar application approx. 3 hours.

APPLICATION

In order to stick the thermal insulation of mineral wool, apply the adhesive in points using no less than 12 points on 1m², the volume of not less than 120cm³ each. Additionally, on the mineral wools boards, apply mortar on the edges to form a frame around the board of a width of 3 cm and a thickness of approx. 1 cm. Stick the insulating boards up to 20 minutes after the mortar has been applied on the wool. The insulating boards arrangement can be adjusted up to 10 minutes since they have been sticked.

PERFORMANCE

Wool sticking – approx. 4 kg/m2. The temperature of the performed works: from +5ºC to +25ºC.

Product Details

100 Items

You might also like

14 other products in the same category:

Our website uses cookies. They ensure the proper functioning of the website. More details can be found in our Cookies Policy. You can change cookie settings in the preferences of your web browser.