Recommended building chemistry!
Can be applied in the following cases:
outdoor and indoor plaster coating, bricklaying of load-bearing, partition and foundation walls, vaults, pillars and load-bearing columns, mounting of all types of anchor elements. It can be used in building elements which have to meet a fire reaction class and thermal insulation requirements.
The product meets the requirements of the PN-EN 998-2:2010 standard for type “G” general purpose grouts with fire reaction class: A1, compressive strength category: M 10 and absorption caused by capillary rise of water: 0.24 kg/(m2*min 0.5).
The product meets the requirements of the PN-EN 998-1:2010 standard for type “GP” general purpose plaster coating with fire reaction class: A1, compressive strength category: CS IV and absorption caused by capillary rise of water: W1.
Mix the bag contents with 4.3 litres of clean water using a drill with a basket stirrer or manually (Note: Using make-up water in a higher amount that it is recommended on the packaging will result in reduction of the mortar’s compression strength below the value declared on the packaging!).
Such prepared mortar should be used according to the building practice, by applying it using a trowel or a flat laying-on board onto typical mineral absorbing building substrates which are clean and free from any substances which reduce adhesion.
Output at plaster coating: 1.45 kg/m2/1 mm of mortar thickness
Consumption time: 2 hours
Temperature of application: +5 to + 25 C