CEKOL GS-83 CONTACT has been specially formulated for priming smooth surfaces, floors and prefabricated elements from prepared timber and concrete to reinforced concrete elements. CEKOL GS-83 CONTACT primer is to be applied in order to improve plaster adhesion to difficult surfaces. Suitable for both interior and exterior use.
*Primer -Coverage: 10 sqm
PROPERTIES:
The CEKOL GS-83 CONTACT preparation is a non-toxic and non-flammable product. It strengthens the surface at the same time increasing the adherence of plasters, putties and mortars. Used when plastering, CEKOL GS-83 CONTACT improves uniformity of plaster, its setting and adhesion as well as facilitates plaster application. After drying, a rough coat is formed on the surface resilient to water and alkaline agents at the same time allowing for water and gases to vapor.
BASE PREPARATION:
The base must be cleaned of loose pieces and particles, dust and also of non-absorbable elements, like oil paints, and all elements not bound permanently with the base. The base must be free of grease.
APPLICATION:
This ready mixed emulsion is to be applied to previously prepared surface in a uniform layer using brush, roller or spray. Protect any nearby elements from getting dirty, any spillage wash immediately with water.
Note: During application and drying air and surface temperature must be in between +5oC to +25oC. Further work may be carried out when the primed surface is fully dry. Drying time, depending on temperature and humidity, is from several to 24 hours.
TECHNICAL DATA:
CEKOL GS-83 CONTACT meets the requirements of PN-C-81906:2003.
Drying time: from several to 24 hours (depending on the temperature and humidity)
Coverage: 10 kg/ 30-40 m² (may differ depending on base absorbability)
Work temperature: +5ºC to +25ºC
Product has the National Institute of Hygiene (PZH) Attestation.
STORAGE:
CEKOL GS-83 CONTACT should be stored in dark compartments (away from sources of heat), protected from overheating and frost. Shelf life is up to 12 months
